For the installation and operation of the fire pump, we operate according to a certain order. When the installation is finished, we should do the corresponding inspection work. This is mainly in order to detect some problems after the installation and correct them in time.
1. China Portable Fire Pump removes grease and dirt from the base and places the base on the foundation.
2, use a level to check the levelness of the base, allow to use wedge iron leveling.
3. Clean the supporting plane of the base, China Portable the plane of the fire pump and motor foot, and install the water and motor on the base.
4. Cement the base and anchor bolt holes China Portable Fire Pump.
5. After cement is dry and fixed, check whether the base and anchor bolt holes are loose, tighten the anchor bolts after appropriate, and re-check the levelness.
6, the coupling should be maintained between a certain gap, check whether the pump shaft and motor shaft center line is consistent, can be adjusted with thin gasket to make it concentric.
7, fire pump installation height, pipeline length. Diameter and flow rate should be calculated to reduce unnecessary losses.
8, long distance conveying should take the larger diameter, pump pipeline should have its own support, do not allow the weight of the pipeline on the pump, to avoid the pump pressure.
9. If the discharge pipeline is installed with a check valve, it should be installed outside the gate valve.
The installation of China Portable Fire Pump is related to the whole operation. Therefore, it is not appropriate to use the pump immediately after installation. Instead, the corresponding correction work should be done to reduce the probability of pump failure, reduce losses, and improve pump efficiency. For the pump, the installation and correction work is a work that requires careful operation, because it is related to the normal use of the pump or not. Therefore, this work must not be careless.
Post time: Aug-03-2022