After the use of water supply equipment for a long time, in addition to the maintenance of it, there is to learn to cool it, why to cool it? In fact, this is easy to explain, marine fire pump manufacturers in continuous work, the equipment will appear fever phenomenon, if not timely solution and treatment, so for the future our operation and use is not small impact, so we must learn to cool it, so what are the specific steps?marine fire pump manufacturers
1. Oil film cooling of the rotor:marine fire pump manufacturers
In this cooling method, a pipe is connected at the inlet of the water supply equipment, and the cooling oil is uniformly dripped to take away the heat of the rotor.
2. Air cooling:
The so-called wet automatic water supply equipment, that is, the air inhaled by the inter-stage or two-stage pump is compressed and transmitted through the combination of comprehensive absorption and phase difference silencer.
3. Water cooling:
The equipment generates heat due to the transport and compression of gas, and this heat needs to be transmitted from the rotor to the housing.
4, the internal cooling of the rotor:
In order to make the equipment work under higher pressure difference, a more effective cooling method can be adopted, that is, the rotor is cooled with circulating oil, and the oil holes and oil diameter shaft heads are respectively driven into the two ends of the pump shaft, and then discharged from the other end through the inner wall of the rotor.
When the temperature of the water supply equipment is increased, it will cause damage to some lines and parts inside the equipment. And it will seriously affect our later use. Therefore, in order to ensure its normal operation, we need to find a reasonable way to control and reduce its temperature.
Post time: Nov-04-2022