For the installation operation of Portable Fire Fighting Water Pump, we carry out the operation in a certain order. After the installation, we should do the corresponding inspection, mainly in order to timely detect some problems after installation and correct them in time. How should the equipment be installed and calibrated? Portable Fire Fighting Water Pump
1, remove the grease and dirt on the base, put the base on the foundation.
2. Check the levelness of the base with a level instrument and allow leveling with wedge iron.
3. Clean up the support plane of the base, the plane of the fire pump and the motor foot, and install the waterway and the motor on the base.
4. Pour the base and anchor bolt holes with cement.
5, cement after dry fixation should check the base and anchor bolt holes are loose, appropriate after tightening anchor bolts, recheck levelness.
6, a certain clearance should be maintained between the coupling, check whether the center line of the pump shaft and the motor shaft is consistent, and can be adjusted with thin gaskets to make them concentric.
7, fire pump installation height, pipeline length. Diameter, flow rate should be consistent with the calculation, and strive to reduce unnecessary losses.
8, long distance delivery should take a larger pipe diameter, pump pipelines should have their own support, do not allow the weight of the pipeline on the pump, to avoid the pump broken.
9, discharge pipeline such as check valve should be installed outside the gate valve.
The installation of Portable Fire Fighting Water Pump is related to the whole use, so it is not suitable to use it immediately after installation, but to do the corresponding correction work, reduce the probability of Pump failure, reduce the loss, and improve the Pump efficiency. For the pump, the installation of the correction work is a need for serious operation of a job, because it is related to the normal use of the pump. So this work should not be careless.
Post time: Jun-27-2022